Add To Your WishlistTurbocharger V-Band Clamp Schwitzer 3LD (Turbine to Bearing Housing) 115mm-123mm Flange

Add To Your WishlistTurbocharger V-Band Clamp Schwitzer 3LD (Turbine to Bearing Housing) 115mm-123mm Flange


Buy in the next
for estimated delivery on


In stock

Sorry we're out of stock!

We can let you know when it's available again, just enter your email address below.


Click here to recommend this product to a friend

Turbocharger V-Band Clamp Schwitzer 3LD (Turbine to Bearing Housing) 115mm-123mm Flange



  • Description - PLEASE ENSURE YOU MATCH FROM YOUR PART NUMBER (DO NOT USE FRAME SIZE I.E. GTB22, K03, RHF5, TD04)

    Specification:

    Turbocharger Band Clamp 3LD (T/Hsg to B/Hsg)

    Torque Rating: 5NM

    Sizes: 3LD

     

    CORRECT TIGHTENING OF YOUR V BAND CLAMP

    Correct fitting of a V-band clamp is vital for correct operation and to ensure you do not suffer premature failure.

    V-band clamps are NOT tightened excessively. They are designed to pinch the mating flanges together whilst allowing movement through expansion and vibration. Over tightening can damage clamps, flanges and in worst case pipe work. 

    To mount your V-band clamp, butt mating flanges together and fit clamp. Tighten clamp to a torque setting of 3.5 Newton Metres (NM). Then, using a rubber mallet, tap around the mating flanges to allow the joints to fully centre and sit without any unequal load. Then increase torque to its final torque setting of 5 Newton Metres (NM).

    Further tapping with a rubber mallet to removing any uneven load from the clamp or flange is beneficial whilst checking the torque setting stays at its rating of 5 Newton Metres (NM).