Add To Your WishlistTurbocharger Turbine Exhaust Clamp V-Band KKK Borgwarner K03 K04 Turbo Flange CHRA (72mm Flange) (similar to 59001095205)

Add To Your WishlistTurbocharger Turbine Exhaust Clamp V-Band KKK Borgwarner K03 K04 Turbo Flange CHRA (72mm Flange) (similar to 59001095205)


Buy in the next
for estimated delivery on


In stock

Sorry we're out of stock!

We can let you know when it's available again, just enter your email address below.


Click here to recommend this product to a friend

Turbocharger Turbine Exhaust Clamp V-Band KKK Borgwarner K03 K04 Turbo Flange CHRA (72mm Flange) (similar to 59001095205)



  • Description

    These cartridge-to-turbine-housing clamps are zinc-coated to prevent from rust.

    Contents:

    1 x Turbine Housing Clamp (includes fixing bolt and nut)

    Specification: 

    Torque Rating: 5NM 

    Outside Diameter:ø76.0mm

    Assembled Size: ø72.0mm 

    Flange Clamping Thickness: 11mm

     

    Application:

    For use on the KKK K03 and K04 turbochargers (amongst others) with 72mm V Band Flange (similar to 59001095205)

     

    Fitment (amongst others):

    5303-970-0086

    5303-970-0105

    5303-970-0248

    Audi A1

    Seat Alhambra

    Seat Ibiza

    Skoda Fabia

    Volkswagen Beetle

    Volkswagen Bjalla

    Volkswagen Eos

    Volkswagen Golf

    Volkswagen Jetta

    Volkswagen Passat

    Volkswagen Polo

    Volkswagen Scirocco

    Volkswagen Tiguan

    Volkswagen Touran

     

    CORRECT TIGHTENING OF YOUR V BAND CLAMP

    Correct fitting of a V-band clamp is vital for correct operation and to ensure you do not suffer premature failure.

    V-band clamps are NOT tightened excessively. They are designed to pinch the mating flanges together whilst allowing movement through expansion and vibration. Over tightening can damage clamps, flanges and in worst case pipe work. 

    To mount your V-band clamp, butt mating flanges together and fit clamp. Tighten clamp to a torque setting of 3.5 Newton Metres (NM). Then, using a rubber mallet, tap around the mating flanges to allow the joints to fully centre and sit without any unequal load. Then increase torque to its final torque setting of 5 Newton Metres (NM).

    Further tapping with a rubber mallet to removing any uneven load from the clamp or flange is beneficial whilst checking the torque setting stays at its rating of 5 Newton Metres (NM).

     

    Average dispatch: 24 Hours

    **PHOTO FOR ILLUSTRATION PURPOSES ONLY**

    THE USE OF MANUFACTURERS NAMES, PART NUMBERS AND SYMBOLS ARE FOR THE USE OF REFERENCING ONLY AND DO NOT IMPLY THE PART IS MADE BY THE SAID MANUFACTURER.

    ALTHOUGH WE MAKE OUR GREATEST EFFORTS TO ENSURE ALL OUR TURBO PRODUCTS ARE DESCRIBED CORRECTLY INCLUDING FITMENT INFORMATION AND DIMENSIONAL REFERENCES, WE CANNOT GUARANTEE THESE TO BE CORRECT AS MISTAKES CAN HAPPEN. WE WILL NOT BE HELD FOR ANY DISCREPANCIES DISPLAYED.